IP power amplifier 650w - Guangzhou Comtom Yongjin Electronics Co., Ltd.

IP power amplifier 650w

CATEGORY： SIP IP PA System TIME： 2019-06-24 ONCLICK： 34

EP-IP650

1. One-way terminal, digital decoding terminal and integrated power amplifier integrated function, the power is 650W.

2. Two-way microphone input, two auxiliary signal input, one network and auxiliary signal input, one auxiliary output.

3.100V, 70V constant voltage output and 4-16Ω fixed resistance output.

4. There is a silent intrusion function, which is convenient for inserting priority broadcast.

5. The power amplifier switch can be automatically controlled.

6. Each signal has independent volume control and total amount control.

7. Treble and bass tone control.

8. Automatic temperature control fan forced cooling and cooling.

9. The MIC1 input jack has the highest priority, and the input signal from this jack will suppress other jack input signals.

1. The device is designed with embedded computer technology and DSP audio processing technology; using high-speed industrial grade chip, the startup time is less than 1 second.

2. Built-in network IP decoding module, support TCP/IP, UDP, IGMP (multicast) protocol, realize network transmission of 16-bit stereo CD sound quality music signal.

3. Built-in 650W fixed resistance (4-16Ω), constant voltage (70V, 100V) power amplifier output, powerful power, free to choose.

4. Two-way microphone input, two auxiliary signal input, one network and auxiliary signal input, one auxiliary output; realize local external audio input and emergency broadcast input, with independent volume adjustment (device needs to test this function to the site, not satisfied Will not be accepted).

5.1-channel audio signal auxiliary output, convenient to extend the external power amplifier (the device needs to test this function to the site, and the unsatisfied one is not accepted).

6. The main volume, high and low sound adjustment knob can adjust the volume according to the actual situation. (This function needs to be tested when the equipment is on site, and it is not acceptable if it is not met).

7. Intelligent power management, when there is no music or call, the device automatically cuts off the main power and enters the standby state. The standby power is less than 3W, which meets the national energy-saving certification requirements. At the same time, the software can set the pre-open main power time in advance.

8. Manual / automatic: power amplifier power supply, manual automatic switch. (This function needs to be tested when the equipment is on site, and it is not acceptable if it is not met).

The serial port of the 9.1 road reserved PC download address can be adapted to the network address modification in different places (the device needs to test this function to the site, and the unsatisfied one is not accepted).

10. The Ethernet port can be accessed, supporting cross-network segments and cross-route.

11. The supplier is required to provide a mandatory 3C certification for this device.